zondag 30 maart 2014

CQ WPX SSB

On Saturday I made 7 QSO's in the CQ WPX SSB.
I wondered if I could make QSO's in phone with my crippled inverted V.
Last year the top broke.
I temporarily repaired the antenna, but one wire lays flat on the roof.
In the last months, I noticed that I need more power than before in CW contest QSO's.
Also I had to rediscover the "tuner settings" for each band, after the antenna had changed.

SSB also works
Using SSB in stead of CW gives a lot more QRM in the house.
Sometime I want to hold the microphone to my ear, to listen. hi
Saturday afternoon I had one hour to operate, in which I made 5 QSO's on 21 MHz with
LZ, IS0, I and EU.    I responded to signals that were S+.

Tuning
In the evening I went on, but could not be heard. The in coming signals were S+, thus strong enough, but my QRP signal could not be heard. After not being heard by 3 different very loud stations I checked my power.
After tuning with CW, as I always do, I had forgotten to switch back to SSB, so I had no power at all.
After that I made two additional QSO's. Then I had to QRT, since the XYL went to bed.

Your signal is weak
On Sunday morning I easily made 5 QSO's on 7 MHz over short distances with DL, ON , PA and G.
Many operators told me that my signal was weak. But I have no tower, no Yagi, a less than perfect Inverted Vee and QRP and still managed to make QSO's, somtimes pushing the operating pratice to the limit at both ends.
Using QRP and a simple antenna, shows that Progation is more important than the Antenna. hi.

zaterdag 29 maart 2014

Pacemaker

De pacemaker heeft vanaf 1958 een enorme ontwikkeling doorgemaakt, zowel in de electronica als de behuizing. De eerste pacemakers waren uitwendig en waren uitgevoerd met buizen, in kasten op wieltjes.
Later kwamen de uitvoeringen met transisitoren, die toen nog op het lichaam gedragen werden.

Nostalgie
Net als mijn eerste zelfgebouwde radio, de Philips Pionier, waren de eerste getransistoriseerde pacemakers met PNP transistors uitgevoerd.
Schema van een pacemaker met PNP transistoren
Uitwendige pacemaker in Kiwi schoensmeer doosje 1958
Nu
De huidige pacemakers bevatten een complete computer, uiteraard zonder toetsenbord en monitor en worden in het lichaam gedragen. De computer maakt de pacemaker programmeerbaar en stelt deze in staat om onregelmatigheden in de hartslag op te merken en op te slaan in het geheugen. Zodat deze info later tijdens het bezoek een aan het ziekenhuis uigelezen kan worden. De pacemaker bevat een batterij, omdat deze langer mee gaat dan een accu.


Voor het verbinden van de pacemaker met het hart worden twee elektroden gebruikt.
De elektrode

Uitvoeringsvormen van de punt van de elektrode 

De foto's zijn gemaakt tijdens de zeer informatieve bijeenkomst voor pacemakerdragers in het st Antonius ziekenhuis in Nieuwegein.  Ik heb mij hier beperkt, tot het ,voor het "radio" Blog, interessante gedeelte.

vrijdag 14 maart 2014

Homebrew 10 watt dummy load

For years I use a very simple homebrew 50 ohm - 10 watt dummy load.
At a moment, I realized that 20 resistor of 1000 ohm in parallel, form a resistor of 50 ohms.

So I bought twenty 1000 ohm - 1/2 watt resistors and soldered them on a PL 259 connector.
Through the green tube runs a wire, to connect the wires of the resistors to the left, with the
center conductor of the connector.
The twenty resistors can dissipate a power of 10 watts.

The dummy was measured in a workshop of Rohde & Schwarz.
At the moment I can not find the report of the measurement.
I first wrote that the dummy load was 49.9 ohms, but I now remember
that it was 49.8 ohms.
I was surprised the resistors had an accuracy of better then 1%. hi

10 watts - 50 ohm HF dummy load
  

vrijdag 7 maart 2014

Spring

Looks like it will be spring.
We have very nice temperatures.
Yesterday my wife and I went for a walk in Rhijnauwen, along the Kromme Rijn.

Langs de Kromme Rijn
Sneeuwklokjes